ENGLISH
BLACKSTONEPRODUCTS.COM
OWNER’S MANUAL | OPERATION INSTRUCTIONS
STEP 02
Turn gas ON by turning
the gas cylinder handwheel
counterclockwise 1 to 3 turns.
2. BATTERY POWERED IGNITION
STEP 01
Insert one (1) AA
battery (not included) under the
ignitor button.
Screw the button into place over
the positive terminal.
STEP 03
❷
Push and hold the ignitor button.
❸
Push and turn the control knob counter-clockwise to HIGH.
(Release the ignitor button when the burner lights.)
❹
Adjust the temperature to desired level.
IGNITION INSTRUCTIONS
1. CHECK VALVES
Ensure gas is o at the supply shut o valve before checking
appliance valves.
STEP 01
Turn all knobs to the
❶
OFF position.
STEP 02
Push in knob and release. Knob should spring back.
If knobs
DO NOT
spring back, replace valve assembly before using appliance.
spring back, replace valve assembly before using appliance.
STEP 03
Rotate knob to LOW then turn back to OFF. Knob should
turn smoothly.
Clean the battery and appliance
Clean the battery and appliance
contacts prior to battery installation.
contacts prior to battery installation.
❷
❸
❶
❹
HEALTHY FLAME PATTERN YELLOW OR IRREGULAR
3. ALWAYS CHECK BURNER FLAME BEFORE USE.
Light burners and look below the cooking surface to view burners.
When knob is at HIGH, flames should be larger than when knob
is at LOW.
3. ALWAYS CHECK BURNER FLAME BEFORE USE.
Light burner and look below the turntable to view burner. When knob
is at HIGH, flames should be larger than when knob is at LOW.
a
a
Flickers of yellow.
b
Dark blue.
c
Vibrant blue.
If flames are yellow or irregular,
If flames are yellow or irregular,
please reference the Troubleshooting
please reference the Troubleshooting
chapter.
HEALTHY FLAME PATTERN YELLOW OR IRREGULAR
a a
Flickers of yellow. Flickers of yellow.
b b
Dark blue. Dark blue.
c c
Vibrant blue. Vibrant blue.
If there is a sudden drop or low If there is a sudden drop or low
flame issue, please reference the flame issue, please reference the
Troubleshooting chapter. Troubleshooting chapter.
WARNING
If burner does not ignite with open gas supply valve, gas
will continue to flow out of burner and could accidentally/
inadvertently ignite with risk of injury.
If ignition does not occur in 5 seconds:
1. Turn the burner control knob OFF.
2. Wait 5 minutes.
3. Repeat the lighting procedure.
If burner does not ignite, please reference the Troubleshooting chapter.
If burner does not ignite, please reference the Troubleshooting chapter.
WARNING
If burner does not ignite with open gas supply valve, gas
will continue to flow out of burner and could accidentally/
inadvertently ignite with risk of injury.
If ignition does not occur in 5 seconds:
1. Turn the burner control knob OFF.
2. Wait 5 minutes.
3. Repeat the lighting procedure.
If burner does not ignite, please reference the Troubleshooting chapter. If burner does not ignite, please reference the Troubleshooting chapter.
MODEL(S): 2311 • 2311CA
To Next Page
Loading...
