BLACKSTONEPRODUCTS.COM
ENGLISH
| OWNER’S MANUALOPERATION INSTRUCTIONS
APPLIANCE STORAGE
WARNING
DO NOT move the appliance when in use. Allow the appliance
to cool to 115°F (45°C) before moving or storing.
Cover your appliance with a hard or soft cover or carry bag (as appli-
cable) when stored outdoors. DO NOT store where water will pool.
FIND MY COVER
BlackstoneProducts.com
• Covers
• Carry bags
CARE AND MAINTENANCE
WARNING
Grease build up can cause a fire. Clean any part of the
appliance that gets hot and experiences grease build up
after each use.
CAUTION
All cleaning and maintenance should be carried out when the
appliance is cool and everything is turned OFF.
• DO NOT use abrasive pad on areas with graphics.
• If a bristle brush is used to clean any of the cooking surfaces,
ensure no loose bristles remain on cooking surfaces prior
to cooking.
APPLIANCE BODY:
Wash with warm soapy water and immediately wipe dry with a
non-abrasive cloth. (DO NOT allow cleaning agents to rest on any
porous surface for a prolonged amount of time.)
NOTICE
DO NOT use Citrisol, abrasive cleaners, or a concentrated
cleaner on the appliance. This may result in damage to and
failure of parts.
STEP 06
Carefully replace
burners and reattach, with
attention to the location of the
ignition needle.
The gas rail fuel nozzle
must be reengaged within the
burner opening.
STEP 01
Ensure that the gas is turned OFF at control knobs and gas
supply. Remove the griddle top.
CLEANING THE BURNER ASSEMBLY
Spiders and insects can nest within and clog the burner/venturi tube
at the orifice.
To reduce chance of “flash-back” the procedure below should be
followed at least once a month when spiders are most active or
when your appliance has not been used for a period of time.
STEP 02
Carefully detach and
remove the burner.
STEP 03
Clean the inside of
the burner:
• Run a narrow bottle
brush through the burner
several times. (DO NOT use
wire brushes)
• Use compressed air to blow
out the burner. (Wear eye
protection)
STEP 04
Brush entire
outer surface of burner to
remove grime.
STEP 05
Clean any blocked ports
with sti wire such as an open
paper clip.
VIDEO TUTORIAL
How to Clean Your Burner Tube
youtube.com/watch?v=xKQTCrFCzf8
WARNING
A clogged burner can
lead to a fire beneath the
appliance.
Burner should be removed
and cleaned whenever
blockages are found.
Fuel nozzle
Burner opening
Venturi
Air intake
Blocked burner
MODEL(S): 2311 • 2311CA
To Next Page