101
E x terior E q uip m ent
Typical Table & Pedestal Installed
Table Mounting Bracket & Spring Loaded Pin
Bow Seating Area
The bow area is equipped with seats, a grab rail and
built in drink holders that drain to the bilge.
The anchor locker and windlass are located just for-
ward of the bow seating area. The area is illuminated
by LED lights recessed into the seat bases. The
lights are activated by the Cockpit Lights switch in
the helm switch panel.
The optional cockpit table is mounted to a bracket
on the rear facing bench seat base. Refer to the
cockpit table section in this chapter for instructions
on installing the table.
Bow Seats and Storage Compartments
The bow seat area is equipped with a molded in, aft
facing bench seat and forward facing seats with fold-
ing armrests. Two shbox/storage compartments are
located below the port and starboard seats. The bow
seat cushions are secured to the seat base hatches
with snaps and should be removed and stored when
the boat is not being used.
The port and starboard compartments are insulated
and can be used for dunnage, coolers or shboxes.
They are equipped with gas charged springs that
hold them in the open position and ush, lift to
release latches that secure the hatches when they
are closed. The compartments drain overboard
by gravity through ttings in the hull sides. If the
compartments are used as shboxes or coolers, they
should be cleaned and ushed thoroughly with fresh
water after each use.
Cockpit Table
A removable cockpit table mounts to a bracket on the
rear side of the bow aft facing seat base. The table
and pedestal are stored in special mounting brackets
built into the helm storage compartment. A spring
loaded pin in the side of the mounting bracket se-
cures the table pedestal in the bracket and prevents
it from working loose while the boat is underway.
To use the table, remove the table and pedestal from
the storage compartment. Pull the safety pin in the
side of the mounting bracket and insert the pedestal
base rmly in the bracket, then release the pin and
make sure it extends into the pedestal base to secure
the pedestal to the base. Then install the table on the
pedestal. Reverse the process to remove the table.
The table should only be used while running at slow
speeds, at the dock or at anchor. Always remove and
properly stow the table and pedestal before operat-
ing the boat above slow speed. To prevent damage
Bow Storage Compartment/Cooler/Fishbox
to the table or storage compartment, make sure to
secure the table with the rotating latch when it is
stored in the mounting brackets. Also make sure
the pedestal is securely fastened to the brackets.
To Next Page
