75
R a w W a ter S y stem
The livewell seacock valve should be closed when-
ever the livewell is not in use. This will prevent
water from entering the livewell while the boat
is cruising.
Notice:
Do not use the livewell as a dry storage
area when it is not in use. Seawater could
accidently be delivered to the livewell from
thethru-hullttinganddamageequipment
stored there.
A RUPTURED RAW WATER INTAKE OR PRESSURE LINE
COULD CAUSE THE BOAT TO TAKE ON WATER AND SINK.
ALWAYS TURN THE RAW WATER SYSTEMS OFF AND
CLOSE THE THRU-VALVES WHEN LEAVING THE BOAT
UNATTENDED.
8 . 4 R a w W a ter S y stem M a intena nc e
The following items should be done routinely to
help maintain your raw water system:
• Check hoses, particularly the seawater supply
lines, for signs of deterioration. Tighten ttings
or replace deteriorated hoses and components
as necessary.
• Periodically remove and clean the water
strainer located on the intake tting on the
side of the livewell pump. To clean the strainer,
make sure the Raw Water Pump switch is o
and close the valve at the thru-hull tting.
Rotate the strainer bowl counterclockwise
to release it. Remove and clean the screen
with fresh water. Lubricate the O-ring lightly
with silicon or Teon grease and reinstall the
strainer bowl.
• Spray the washdown pump with a protective
oil periodically.
• Fishboxes and livewells should be drained and
cleaned after each use.
• Operate all seacock valves at least once a
month to keep them operating properly.
Livewell Pump & Sea Strainer
Typical Raw Water Pump Strainer Removed for Cleaning
SHOULD A HOSE RUPTURE, TURN THE PUMP OFF
IMMEDIATELY. ALWAYS CLOSE THE THRU-HULL VALVE
WHEN PERFORMING MAINTENANCE ON A SEAWATER PUMP.
THE BATTERIES MUST BE PROPERLY CHARGED.
OPERATING ANY PUMPS FROM A BATTERY WITH A LOW
CHARGE MAY LEAD TO A PUMP FAILURE.
THE RAW WATER SYSTEM MUST BE PROPERLY WINTERIZED
PRIOR TO WINTER LAY-UP. SEE SECTION ON WINTERIZING.
To Next Page
Loading...
