103
E x terior E q uip m ent
just enough to pull out the wrinkles and reach the
snaps on the windshield.
Once the windshield connector is completely in-
stalled, the side curtains can be put on. Zip the
side curtains to the valances on the sides of the
hardtop and to the front connector. Snap the
curtains to the windshield and the deck beginning
with the forward snaps on the windshield. The side
curtains will have to be stretched slightly to pull
out the wrinkles and reach the snaps.
There is a panel in the windshield connector that
can be rolled up and secured by straps near the top
of the curtain. This roll up panel allows the walk-
through feature of the cockpit and windshield to be
used when the windshield connector is installed.
If your boat is equipped with an optional rear drop
curtain, lay the curtain on a soft surface that won’t
scratch the clear vinyl and unzip the valance from
the curtain. Slide the valance into the slide track
on the rear of the hardtop. Zip the drop curtain
to the valance on the back of the top and to the
rear of the side curtains. Attach the curtain to the
deck and cockpit.
Bow Cover, Windshield Connector, Side Curtains & Aft Enclosure
Drop Curtain
To Next Page
