40
P rop ulsion S y stem
Depth Gauge (Optional)
The depth gauge indicates the depth of the water
below the bottom of the boat.
Compass
All boats are equipped with a compass in the in-
strument panel. The compass cannot be adjusted
accurately at the factory as it must be compen-
sated for the inuence of the electrical equipment
and electronics unique to your boat. Therefore,
the compass should be adjusted by a professional
after the electronics and additional electrical ac-
cessories are installed and before operating the
boat. To adjust the compass for your area, read
the instructions on “Compass Compensation”
given to you in the literature packet.
Instrument Maintenance
Electrical protection for instruments and ignition
circuitry is provided by a set of fuses or circuit
breakers located on each engine. The ignition
switches should be sprayed periodically with a
contact cleaner/lubricant. Ignition switches and
all instruments, controls, etc. should be protected
from the weather when not in use. Excessive
exposure can lead to gauge and ignition switch
diculties.
Compass
To Next Page
Loading...
