BLACKHAWK! V-2 - Measure Length of the Rod and Cut

Blackhawk Technology Company
V-2PneumaticPistonPumpI&O-10365 | 20220811 10
6. MEASURE LENGTH OF THE ROD AND CUT
SeeRodCungDiagramonnextpageforreference.
 See Step 1.
b. Mark the rod at the top of the tee or pipe union with a marker. See Step 2.
c. Pull 3 to 4 feet of rod from the well. See Step 3.

union.Clamp vice grips to the tape. NOTE: This secures the drive rod at the
surface and prevents rod from dropping into the well. See Step 4.
 
and make a second mark. See Step 4.
 
Cut on both sides to ensure the rod does not split. See Step 4.
g. When cut correctly, there will be an 8 inch gap between the top of the piston

the stroke.