BLACKHAWK! V-2 - Install the Top Head Driver with Ferrule and Nut

Blackhawk Technology Company
V-2PneumaticPistonPumpI&O-10365 | 20220811 12
Seeguresonnextpageforreference.
a. Retrieve the ferrule and nut from the actuator. They will be loosely fastened to
the actuator’s rod to motor connect. See Step 1.

outward, onto the rod. Then lower the ferrule onto the drive rod. See Step 1.
c. Retrieve the actuator and slide the drive rod into motor connect with the ferrule
and nut below it. See Step 2.


ferrule will have mushroomed out and there will be a faint white line where the
ferrule has dug into the rod. See Step 2.
 

 
leaks.
 

7. INSTALL THE TOP HEAD DRIVER WITH FERRULE AND NUT