Overview ......................................2
Preinstallation .................................4
1. Unpack ..........................................4
2. Gather tools .....................................4
3. Measure the well depth ...........................5
4. Uncoil the rod ...................................5
5. Choosing the riser pipe ...........................6
6. Lay out the pump system .........................7
Installation ....................................8
1. Assemble the downhole components ..............8
2. Install the vanstone flange .......................8
3. Lower the pump into the well ......................8
4. Inspect the well seal .............................8
5. Lower the piston into the well .....................9
6. Measure length of the rod and cut ............... 10
7. Install the top head driver with ferrule and nut .... 12
Start Up ......................................14
1. Turn on the actuator ........................... 14
2. Complete installation .......................... 14
Maintenance ..................................16
Troubleshooting Guide .........................18
Appendix .....................................20
Contents
To Next Page
Loading...