Viewing your Inputs
To see which of your Blackmagic MultiView 16’s video inputs is routed to a particular view, click
a view pushbutton in the destinations panel. The destination, or view, button will illuminate. In
the ‘sources’ panel, the pushbutton of the routed video input will also illuminate, making it clear
which input, or source, is routed to the view.
Routing Inputs to Views
To route a video input to a view, click a view pushbutton from the destination panel, then click
an input pushbutton in the sources panel to immediately route that input to the view.
Solo Input
Use the “solo input” pushbutton to determine which input is displayed full screen when the
“solo” button is enabled on the Blackmagic MultiView 16’s front panel. Simply click on the “solo
input” pushbutton in the Videohub Control destinations panel, then click an input pushbutton in
the sources panel.
Audio Input
On Blackmagic MultiView 16 and Blackmagic MultiView 4 you can use the “audio input”
pushbutton in Videohub Control software to determine which SDI input’s audio is routed to the
multi view output. Simply click on the “audio input” pushbutton in the Videohub Control
destinations panel, then click an input pushbutton in the sources panel to immediately route
that input’s audio to the multi view output.
The “solo input” and “audio input” pushbuttons allow
you to change these settings using Videohub Control
34Using Videohub Control Software
To Next Page
Loading...
Need help?
General
