What to do if my Bladelius Thor Amplifier has no sound?
If your Bladelius Amplifier isn't producing any sound, here's what to check: * Ensure the AC Mains cable is properly plugged in and the power is switched on. * Make sure the TAPE MONITOR mode is de-selected. * Verify that Mute is switched off. * If none of these resolve the issue, consult your dealer as an internal fuse may have blown.
Why is there no sound in one channel of my Bladelius Amplifier?
If you're experiencing sound in only one channel of your Bladelius Amplifier, the issue might be due to: * A speaker that is not properly connected or is damaged. * An input lead that is disconnected or damaged. Check the speaker connections and the condition of the speakers themselves. Also, inspect the leads and their connections to ensure everything is properly connected.
What to do if Bladelius Thor remote control handset not working?
If the remote control for your Bladelius Amplifier isn't working, try these steps: * Check the batteries to ensure they are correctly inserted or replace them with new ones. * Make sure there are no obstructions blocking the IR transmitter or receiver windows.
How to fix weak bass or poor stereo image on Bladelius Thor Amplifier?
A weak bass or poor stereo image with your Bladelius Amplifier is often caused by speakers wired out of phase. Check the connections to all speakers in your system to ensure they are correctly wired.
General| Type | Integrated Amplifier |
|---|---|
| Total Harmonic Distortion | < 0.05% |
| Damping Factor | >200 |
| THD | <0.05% |
| Outputs | Pre-out |
Required break-in period for the unit to reach maximum sonic potential, typically 5-6 weeks.
Focus on unobtrusive design that harmonizes with environments, reflecting tonal ability and balance.
Uses two signal lines with opposite phases to cancel noise interference for pure signal transfer.
Connects your power amplifier to the Thor using RCA connectors for pre-amplifier use.
Ensure consistent channel connection for accurate tape playback and recording.
Compatible with typical analog line level sources like DAT, MD, DVD, VCR, or tape decks.
Outputs marked +/- connect to corresponding loudspeaker connectors for sound reproduction.
Intended for sources with XLR-outputs; use RCA line-inputs if XLR is not available.
Used for control from auxiliary equipment like PCs, or for service/software upgrades.
Firmly plug the AC cord into the receptacle and connect to a wall outlet directly.
Keep the Thor on or in standby mode for best results; do not switch off unless unused long-term.
Use this button to cycle through and select the current input source.
Push the button to adjust the display brightness to desired levels.
Use the 'wheel' to conveniently adjust and control the output listening level.
Shows the unit's current status; all functions are accessed via the remote control.
Activates specific control buttons related to amplifier functions.
Switches the amplifier unit on and off.
Mutes the sound output temporarily.
Dims the front panel display through four steps, including off.
Activates and steps through the unit's menu options.
Changes the input source selection for the amplifier.
Controls the master volume level of the amplifier.
Toggles surround mode by holding for over two seconds.
Directly selects the input source using numbered buttons.
Adjust input sensitivity for each source via the DISPLAY and VOL +/- buttons.
Rename inputs using SOURCE/DISPLAY/VOL buttons to customize character by character.
Bypass preamplifier section by holding MODE/AUDIO for 2s for direct connection or external processor use.
Remove two screws to access the battery compartment; match battery polarity for installation.
Check power, tape monitor, mute, fuse, speaker connections, and input leads.
Verify speaker wiring phase and system connections.
Replace batteries, check for obstructions, and ensure clean sensor/emitter windows.
Obtain return authorization from Technical Services BEFORE shipping; provide detailed problem description.
Use original packaging; improper packaging may result in shipping damage at owner's expense.
To Next Page