9
Input Settings
INPUT LEVEL
To change the input level, select the input you wish to
change, then step through the menu by pressing DISPLAY
until “Input level” is shown in the display window. To adjust
input sensitivity, simply press VOL+ to increase the input
level or VOL- to decrease the input level. When set to the
desired level, exit the menu by pressing the DISPLAY button
4 times until your input name is again displayed. Your new
level is now stored in memory. You may store different levels
for each input as they are stored independently in memory.
If you do not wish to use this feature, it is best to leave the
input levels at their factory preset level of “0”.
NAME
Select the input name you want to change by using the
SOURCE +/- button. Press the DISPLAY button to activate
the menu and continue to press the DISPLAY button until
EDIT INP NAME is shown in the display. Press VOL + and
you will see the first character of your previously selected
input name flash. Use VOL +/- to change the character and
then step to the other characters using SOURCE +/-. When
you have finished changing the name exit the menu by
pressing the DISPLAY button 3 times until your new name is
displayed.
SURROUND MODE
To bypass the preamplifier section of the Thor you press the
MODE/AUDIO button on your remote for 2 seconds. “SURR”
will be displayed next to your currently selected input. In
this mode Line 5 (TAPE) will be directly connected to the
amplifier bypassing the internal preamplifier circuits.
If you have a surround sound processor and want to use
your Thor in “pre-amplifier bypass” mode, press the MODE/
AUDIO button for more than two seconds. Select which in-
put you want to connect to the TAPE OUT connectors on the
back of your Thor. You can now use TAPE OUT as an input
to your surround sound processor. TAPE is then used as
your input coming back from the surround sound processor
and will be connected to the internal amplifier.
NOTE:
The Thor is equipped with a non-volatile memory which will
remember all of the settings you have edited, allowing auto-
matic access to the same settings (volume, input selection,
alias names, etc.) that you last used before placing the unit into
standby mode or if you turn the mains switch off.
To Next Page
Loading...