BLADEZ Evora - Console Overview and Functions

17
CONSOLE OVERVIEW
TIME 00:00-99:59
SPEED 0.0-999.9KM/H or ML/H
DISTANCE 0.00-999.9KM or ML
TOTAL DISTANCE 0-999K
CALORIES (CAL) 0 -999.9KCAL
KEY FUNCTIONS:
MODE: is key lets you select and lock on to a particular function to view.
1. AUTO ON/OFF:
e system turns on when any button is pressed or when it receives a signal input from the speed
sensor. e system turns o automatically when the sensor has no signal input and no buttons
have been pressed for approximately 4 minutes.
2. RESET:
e unit can be reset by either replacing the batteries or pressing the MODE button for 3 seconds.
3. MODE:
e computer can display one of 5 parameters; Time, Speed, Distance, Total Distance and
Calories. Pressing the MODE button repeatedly until the desired parameter is displayed. Press
the MODE button to move to the next parameter or loop through all sections manually. ere
is also a SCAN display. Press the MODE button until SCAN is ashing in the lower left corner.
Under this selection, the computer will automatically display each parameter one-by-one for 3
seconds in the order of Time, Speed, Distance, Total Distance and Calories.
4. FUNCTIONS:
TIME: Press the MODE button until the pointer advances to TIME. e total working time
will be displayed.
SPEED: Press the MODE button until the pointer advances to SPEED. e speed will be
displayed either in MPH or KPH.
DISTANCE: Press the MODE button until the pointer advances to DISTANCE. Each workout
distance, total distance will be displayed.
CALORIES: Press the MODE button until the pointer advances to CALORIES. e calories
burned will be displayed.
SCAN: e following functions will be displayed in the order shown: TIME, SPEED,
DISTANCE, TOTAL DISTANCE, CALORIES (repeat).
BATTERY: is monitor uses one AA battery. If the display on the monitor is not clear, install
new battery.