20
Cleaning the oven door
For a more complete cleaning of the oven
door it is advisible to proceed by dismantling
it as follows: open the door completely; raise
the small levers fixed to the two hinges and
turn them fully towards the door; reclose the
door until it touches the levers; then, press
the door in the direction of closing and pull it
outwards to remove it. (Fig. 8)
Lay the door down on a flat horizontal surface.
After having cleaned the door, replace it as
follows:
1. Clasp the two hinges on either side of
the door together simultaneously.
2. Hook the top hinge into the top slot, so
that the hook is engaged with the roller.
3. Drop the lower hinge into the lower slot,
so that the notch is engaged. Drop the
door down so it is in the horizontal
position.
Note:
It is important when carrying out this operation
that both hinges be located simultaneously.
Fig. 8
FO 0288
Removing the oven shelf
supports
Unscrew the ring nuts securing the shelf
supports (Fig. 7) and remove the supports
after sliding them out of their retaining pins.
Warning
Always unplug the appliance before removing
the back panel.
To remove the back panel use a screwdriver.
This is a good opportunity to clean the back
of the rear panel.
Wash the panels with very hot water and a
detergent using a soft cloth.
If the shelf supports or the panels become
very soiled, use a standard non-caustic
product specially made for cleaning ovens.
Fig. 7
FO 0145
To Next Page
Loading...
