ACCESSORIES
It is recommended that you use the containers indicated depending on the food you will cook in your oven.
You can also use glass containers, cake pans and special oven trays suitable for use in your oven
(available in kitchenware shops). Pay attention to the information given by the supplier for use of this
cookware. The information given below should be implemented for enamelled containers.
This appliance is supplied with two wire shelves and one baking tray with grill insert. The removable wire
handle can be used to insert and remove the baking tray.
If the food to be cooked does not completely cover the oven tray, if the food is taken out of the deep-freezer
or if the tray is used to collect the dripping juices of the foods during the grill operation, deformation might
be observed on the tray over time due to high temperatures forming during the cooking/baking operation.
This is a normal, physical state that results during the heat transfer. Do not leave a glass tray or container
in a cold environment immediately after cooking in them. Do not place them on cold and wet surfaces.
Ensure that they slowly cool off by placing them on a dry piece of cloth or wooden board, otherwise, the
glass tray or container might break. If you are going to use your oven to grill, we recommend using the grill
rack on the tray, supplied together with your product. This way, splattering and dripping oils will not make
the oven interior dirty. If you are going to use the large wire oven rack/grill, insert a tray into one of the lower
racks to collect fat or oil. To make cleaning easier, add some water into this tray. In a grilling operation, use
the shelf in position 4 or 5.
ANTI-TIP SHELVES AND TRAYS
Each anti-tip shelf and tray comes
with a built-in safety feature to help
minimise them being accidentally
pulled fully out. This comes in the
way as a “step”, positioned part-
way in from the rear of the anti-tip
shelf or tray.
To fit them into the oven, push the
anti-tip shelf or tray part way into
the oven until the step “catches”,
then angle the part over the step &
fully insert. To remove, repeat the
process in reverse.
WARNING: Accessible parts may become hot when the grill is in use. Children should be kept away.
USING THE TELESCOPIC RUNNERS
The telescopic runners allow you to fit a supplied tray or shelf, and pull it fully forward. The telescopic
runners come in pairs (a left and a right) with the front a flat bar at the front.
To fit the telescopic runners, remove the side shelf support and place on a table (telescopic runner to the
bottom) with the flat plate to the front. Use a small screwdriver to unclip the telescopic runner from a side
shelf wire and push the runner back over another wire (only the top ones of each pair). Fit the side shelf
supports back in position. Extend the runner fully out and place the tray or shelf on top (between the flat
plate and the round stopper at the rear). Push fully in before closing the oven door.
To Next Page
Loading...
