39
Safety Instructions
Only original BLANCO CO
2
cylinders with a standard capacity of 425 g may be used in
the system. When screwing the cylinder into place, always ensure that it is air-tight when
inserted. Tighten a little more after inserting to ensure the cylinder is properly fitted. When
you screw it in to place, there may be a slight hissing sound and small amounts of CO
2
may leak out. This is not a problem.
The cylinders are pressurised. Protect the cylinders from direct sunlight, sources of heat and
overheating. Store CO
2
cylinders in an environment where they won’t be exposed to heat. Rooms
where the system is installed must be at least 5 m
2
in size. If the room is less than 2 m high, it needs
to have a greater area.
WARNING: inhaling CO
2
poses a threat to life! Do not make any modifications to the installation or CO
2
cylinders. If CO
2
should leak into a room, ventilate the room and leave it to air for some time. However,
the total amount within the installation is not sufficient to produce life-threatening concentrations in
the air if it leaks out. Do not operate the system for an extended period with an empty CO
2
cylinder or
without a cylinder inserted as this can cause water damage. The CO
2
cylinder must be removed if you
need to transport the system.
Do not use osmosis water or highly filtered water in the system. This can cause problems with the fill
level control.
The spray head holder contains a strong magnet. Patients with a pacemaker should keep a distance of
at least 15 cm.
Take country-specific installation and operation requirements into account.
WARNING – hot water:
CAUTION – burns/scalding
The hot water that comes out of the tap can be very hot, depending on the setting, and can cause
burns.
The tube connection on the water conditioning unit rear, the mixer tap lower parts and the red
connection tube to the mixer tap can be very hot. Ensure that these are securely installed and
inaccessible at all times.
Do not touch the outlet for hot water on the lower surface of the rotary arm and do not touch this
dispensing outlet to turn the arm either. It can be very hot or water which is still very hot can drip out.
The surface of the rotary arm can also become uncomfortably hot when hot water has been dispensed
continuously.
Sink surfaces may become discoloured if boiling water is allowed to splash constantly onto the same
spot in composite kitchen sinks.
Check that the safety assembly module works properly on a regular basis. To do so, turn the knob
on the safety assembly module in the direction indicated and let water run into the drip cup. Check
whether the expansion water drips into the drip cup while the boiler is heating up.
To Next Page
Loading...
