5151
Changing CO
2
cylinders
Tilt CO
2
cylinder
backwards.
Insert front flap at the
bottom and close at top.
When you dispense sparkling water after the cylinder has been changed, you may need to
dispense one or two times before the sparkling performance returns to normal.
+
The correct position is important: screw the cylinder into
the thread up to the mechanical stop when inserting.
Then tighten by about another 1/4 turn to ensure that
the cylinder is firmly in position.
When you screw the cylinder in and out, there may be a
slight hissing sound and small amounts of CO
2
may leak
out. This is to be expected.
WARNING:
Do not operate the system for an
extended period with an empty CO
2
cylinder or without a cylinder inserted
as this can cause water damage.
On the display CO
2
service life is reset automatically
and red LED on mixer tap goes out automatically.
Only original BLANCO CO
2
cylinders with a standard
capacity of 425 g may be
used in the system.
To Next Page
Loading...
