1-7D Operating Instructions
Initial operation
Lubricate the wheel bearings of the drive wheel every 100 working
hours.
Make sure the dust container of the filter unit is empty. Please
comply with the local waste treatment regulations considering the
removed material.
Check the separator parts for wear and defects. Remove foreign
bodies and dust deposits in order to prevent the separator from
being blocked.
Check the electrical connections for dirt and foreign body
deposits.
Check the electrical motors for dirt and other contaminants.
Check the level of abrasive in the storage hopper. Refill if
necessary.
Before start-up the operating personnel must be familiar with the
safety regulations given in this manual.
Place the blast cleaning machine and the filter unit onto the
surface to be treated.
Check the height adjustment (approx. 6 mm) of the blast
cleaning machine.
Fig. 5.1
For the height adjustment, an 6 mm sheet steel strip is shifted
below the magnetic sealing.
3
To Next Page
