Operating Instructions 1-7D
Initial operation
Check the main power cable and the dust hose for damage.
Replace or repair all damaged parts before starting the machine.
Connect the blast cleaning machine and the filter unit with the
dust hose. Use hose clamps at the connections.
Connect the supply cable of the filter unit with the site supply.
Connect the supply cable of the blast cleaning machine with the
site supply. Make sure that the correct electric supply is available
(230V, 50Hz, 16A for 230V plug).
Fill the separator (2) equally with the selected abrasive (see
Chapter 3.9) up to the bottom of the separator tray. The
magnetic valve must be closed whilst doing this.
Fig. 5.2
Fill in abrasive here!
Check that the filter dust container has been emptied. Please
comply with the local waste treatment regulations considering the
removed material.
4
To Next Page
