Operating Instructions 1-7D
Operation
6.4 Switching-off the machine
Release the dead man’s handle for so that it snaps back into its
resting position. The magnetic valve is closed and the blast
motor will stop turning after approx. 10 seconds.
Advance the machine until you are sure that no deep holes are
being blasted into the surface.
Make sure that all turning machine parts have come to standstill
before any inspection or maintenance works are started.
To avoid unintended switching on of the machine, lock the valve
lever with the plunger!
Fig. 6.2
When the ISPC Blastrac/EBE blast cleaning machine is put out of
operation for a longer period of time, pull out the mains plug and
cover the machine with a plastic foil.
6.5 What to do if a fault occurs
Irrespective of the following information, the local safety regulations
are valid in any case for the operation of the machine.
First put the machine to its Safety off position. After that start
looking for the defect.
4
To Next Page
