Operating Instructions BMP-E165
Section 1 - Safety Precautions April 2006
© Blastrac April 2006
9
1.6 Electrical Safety
When extending the main cable, use only extension cables that
are dimensioned in accordance with the machine's total output
and with current regulations.
DO NOT ABUSE THE POWER CORD! Never pull the machine by
the cord! Never allow the cord to be run over by a forklift truck
or any other vehicle! Connect the power cord to the power
source and power cable extensions with approved plugs only
and with the machine power switch turned off.
To protect against unnecessary damage, ensure that no
vehicles, such as forklift trucks, can drive over the electrical
cable or the dust hose!
Electrical components must be checked on an ongoing basis.
Electrical cables, enclosures, and safety devices should be
inspected prior to every shift, EVERY day. Always inspect after
transport. A thorough check of the internal terminations should
be accomplished every 3 months.
If defects are found or suspected, contact a qualified electrician
or your Blastrac representative. Defects such as loose
connections or scorched cables must be corrected immediately.
Ensure reliability of voltmeters used for troubleshooting.
To Next Page
Loading...
