7
DEUTSCHEN
Radio mode
Start radio mode
In the main menu, press the Radio button.
The radio playback menu is displayed.
Select memory bank
Dierent memory banks and wavebands are available.
Up to 6 stations can be stored in each memory bank.
Press the button repeatedly until the desired
memory bank is displayed.
FM1
FM2 FM3 AM1 AM2 FM1
Tuning into a station
Tuning into stations manually
Briey press the or button once or
several times to change the frequency in increments.
Enter broadcast frequency directly
If the frequency of the desired stations is known, it can
be entered directly via the touchscreen.
Press the button to display additional
operating options.
Press the button.
A numeric keypad is displayed for the frequency
input.
Enter the frequency of the desired station with the
numeric keypad.
Press the OK button.
The radio playback menu is displayed, the station of
the frequency entered is played back.
Starting station seek tuning
Press the or button for approx. 2
seconds to start station seek tuning.
The radio tunes into the next receivable station.
Note:
For the reception area Europe: In the FM waveband,
only trac information stations are tuned into if the
priority for trac information is switched on.
Storing stations manually
Select the desired memory bank with the
button.
Set the desired station.
Press one of the memory buttons P1 - P6 for
approx. 2 seconds to store the current station at the
button.
The station is stored.
Storing stations automatically
(Travelstore)
With Travelstore, you can automatically search for and
store the 6 FM stations oering the strongest reception
in the region in the current memory bank. Any previously
stored stations in this memory bank are deleted in the
process.
Select a memory band.
Press the [ ] button to display additional
operationg options.
Press the [ TS ] button.
The tuner starts the automatic station seek tuning.
After the storing is completed, the radio plays the
station at memory location 1 of the previously
selected memory band.
Note:
For the Erurope reception area: If trac information
is switched-on, only trac informations are stored.
Scanning stations
You can use the scan function to play all the receivable
stations of the current waveband for a few seconds.
Press the button.
The seek tuning searches for stations in the current
waveband. Each receivable station is played for a few
seconds in the process.
Pressing the [ ] button again selects the currently
scanned station and plays it back.
Adjusting the seek tuning sensitivity
The seek tuning sensitivity decides whether the
automatic station seek tuning nds only strong stations
or also weaker stations that may be noisy.
Press the DX / LO button to adjust the sensitivity of
station seek tuning.
If Local is displayed, only stations with a strong signal
are found during seek tuning.
If Distance is displayed, stations with a strong and
weak signal are found during seek tuning.
Radio mode
To Next Page
Loading...
Need help?
General
