19
Theft protection
Activating the device code
In addition to a detachable control panel, the device is equipped
with a four-digit device code. The device code is set to 0000 at
the factory. With this setting, the coding is not active and the de-
vice can be switched on without code query after a voltage inter-
ruption.
To activate the coding of your device, you must enter a freely
selectable code. How to change the code is described in the chap-
ter “Setup menu” under “Changing the password”.
Note: Record your personal code and keep it in a safe
place. If you ever forget the code, the device cannot
be switched back on after a voltage interruption. In
this case, the device must be decoded by returning it
to a local dealer or sending it to our customer service
department.
Switching on coded devices after a voltage interruption
If a coded device is switched on after disconnecting the battery
voltage, e.g. in case of a repair to the vehicle, the code query
appears.
PASSWORD
PASSWORD
1. Enter the four-digit code using the number buttons 0 to 9
on the remote control.
2. Press the
button to correct any incorrect entries.
3. Confirm the entry with the ENTER button.
✔ The device switches on.
BA IVDM-7003 Teil 1 GB 03.02.2006, 8:32 Uhr19
To Next Page
Loading...
