Blaupunkt ASPEN IVDM-7003 - Switching the Downmix Mode On;Off; Selecting the Display Illumination Colour

25
Introduction
On the remote control:
1. Press the SOUND / DSP button.
✔ The sound effects menu appears on the display.
EXIT
EXIT
NEXTNEXT
ProLogic2
ProLogic2
DownMIX
DownMIX
BALANCE
BALANCE
FADER
FADER
ProLogic Music
OFFOFF
OFFOFF
+0+0
Studio Hall Church
+0+0
Audio Effect Control
Audio Effect Control
OFF StereoStereo Lt/Rt
SFC
SFC
Chicago IVDM-7003
2. Press the ENTER button.
3. Select the sound effect to be set with the
or button.
4. Select the desired setting with the
or button.
5. To perform additional settings, repeat steps 3 - 4.
6. Touch the SETUP button to hide the sound effects menu.
✔ The settings are automatically saved.
Switching the Downmix mode on/off
If the Downmix mode is activated, the multi-channel surround sig-
nal is transferred into a conventional stereo signal.
1.
On the remote control: Press the DOWNMIX button to acti-
vate the downmix mode.
2. Press the button again to deactivate the downmix mode.
Selecting the display illumination colour
The following colours are available for the display illumination of
the device:
Turquoise > Red > Violet > Yellow > White > Blue > Green >
1.
On the device: Hold the DIS / FLIP button pressed until
the colour changes. Repeat the process until the desired
colour is set.
On the remote control: Press the LCD button repeatedly
until the desired colour is set.
BA IVDM-7003 Teil 1 GB 03.02.2006, 8:32 Uhr25