Blaupunkt Bluebot - Cleaning Modes

12
Product Operation
Cleaning Modes
1. Auto cleaning
In this mode, the robot will clean a room automatically and
adjust its cleaning mode according to environment.
Note: Press on robot or ON/OFF on remote control to
start auto cleaning.
2. Spot cleaning
Under the following situations, the robot will activate spot
cleaning:
1). When it detects a very dirty area.
2). Press SPOT on remote control.
Note: It’s suggested that user select spot cleaning in a very dirty area.
3. Edge cleaning
In cleaning mode, press to enter edge
cleaning mode. The robot will clean along the obstacles.
4. Zig-zag cleaning
The robot will automatically goes into zig-zag cleaning when
it detected it is in an open area . Or press on the
robot.
Note:
Press MODE button on remote control to select cleaning mode:
A. Mode No.1111 shows on robot LED display: spiral cleaning mode;
B. Mode No.2222 shows on robot LED display: auto cleaning mode;
C. Mode No.3333 shows on robot LED display: edge cleaning mode;
D. Mode No.4444 shows on robot LED display: zig-zag cleaning mode;