18
MP3-/WMA- MODE
Scanning tracks/files (SCAN)
You can briefly play all the tracks/files
on the CD.
➮ Press the MENU button 9 for
longer than 2 seconds.
“SCAN” appears alongside the blinking
track/file numbers during the scanning
process.
Note:
● You can set the scanning time
(scantime). For further details on
setting the scantime, please read
the “Setting the scantime” section
in the “Radio mode” chapter.
Stopping SCAN and continuing
playback
➮ Briefly press the MENU button 9.
The currently scanned track/file will then
continue to be played normally.
Repeating individual track/file or
whole directories (REPEAT)
To play the current track/file repeatedly,
➮ briefly press button 4 RPT ;.
“RPT TRCK” appears briefly in the dis-
play and RPT lights up.
To repeat the whole directory,
➮ press button 4 RPT ; longer than
2 seconds.
“RPT DIR” appears briefly in the display.
Cancelling REPEAT
To stop the current track or current di-
rectory from being repeated,
➮ briefly press button 4 RPT ;.
“RPT OFF” appears briefly in the dis-
play and the RPT symbol disappears.
Pausing playback (PAUSE)
➮ Press button 3 ;.
“PAUSE” appears in the display.
Cancelling pause
➮ Press button 3 ; while in
pause mode.
Playback is resumed.
Setting the display
Setting the standard display mode
While playing MP3 tracks/files, you can
choose to display one of the following
standard display modes:
● Track/file number and playing time
● Track/file number and clock time
● Directory number and track/file
number
● Directory number and clock time
● Directory number and playing time
The chosen display will be shown after
scrolling the MP3 texts at every change
of track/file.
To set the displays,
➮ press and hold down the DISPL
button 8 for longer than two sec-
onds to change the display mode.
Repeat this step until the desired
mode is shown.
KEYWESTMP36_EN2 3/15/06, 4:38 PM18
To Next Page
Loading...
Need help?
General
