8
ADJUSTING THE VOLUME
Switching on by inserting a CD
If the unit is switched off and there is no
CD inserted in the drive,
➮ press the
button 2.
The release panel opens.
➮ Gently insert the CD with the print-
ed side uppermost into the drive
until you feel some resistance.
The CD will be drawn automatically into
the drive.
You must not hinder or assist the drive
as it draws in the CD.
➮ Gently close the control panel
whilst exerting a little pressure until
you feel it clicks into place.
The unit switches on. CD playback be-
gins.
Note:
● The unit will remain off if the igni-
tion is off. To turn it on, press but-
ton 1 once.
Adjusting the volume
The volume can be adjusted in steps
from 0 (mute) to 66 (maximum).
➮ To increase the volume, turn the
volume control 3 to the right.
➮ To decrease the volume, turn the
volume control 3 to the left.
Setting the power-on volume
You can set the unit’s default power-on
volume.
➮ Press the MENU button 9.
➮ Press the
or button : repeat-
edly until “ON VOLUME” appears
in the display.
➮ Set the power-on volume using the
or buttons :.
To help you adjusting the volume more
easily, the audible volume level will in-
crease or decrease accordingly as you
make your changes.
If you select “LAST VOL”, the volume
played before the unit was last switched
off will be reactivated.
Note:
● To protect your hearing, the maxi-
mum switch-on volume under the
“LAST VOL” setting is “38”. If the
volume was higher before the unit
was switched off and “LAST VOL”
has been selected, the volume will
be set at “38” the next time the ra-
dio is switched on.
When you have finished making your
changes,
➮ press the MENU button 9 twice.
SWITCHING ON/OFF
KEYWESTMP36_EN2 3/15/06, 4:38 PM8
To Next Page
Loading...
Need help?
General
