19
ENGLISH
Troubleshooting
If you suspect something is wrong, immediately switch power off. Immediately stop using it and call the store where you purchased it.
Never try to repair the unit yourself because it is dangerous to do so.
Problem Possible cause Solution
General
No power or no sound. Car ignition is not on.
Cable is not correctly connected.
Fuse is blown.
Volume is set at minimum or the mute
function is on.
Turn your car's key to ACC or ON.
Check connection.
Replace fuse.
Check the volume or switch the mute function off.
If the above solutions cannot help.
Press the
RESET
button.
Disc
Disc is inside but no sound. Disc is upside down.
Disc is dirty or damaged.
Place disc in the correct direction, and the label side up.
Clean disc or change another disc.
Disc sound skips, tone quality is low. Disc is dirty or damaged. Clean CD or change another CD.
Sound skips due to vibration. Mounting angle is over 30°.
Unstable mounting.
Adjust mounting angle to less than 30°.
Mount the unit securely with the mounting parts.
Radio
Noise in broadcasts. Station is too far, or signals are too weak. Select other stations of higher signal level.
Preset station lost. Battery cable is not correctly connected. Connect the battery cable to the terminal that is always live.
Error Display Messages
Display shows ERROR. Disc is dirty, damaged or upside down.
Press
to eject the disc.
When video file initializing time is too long. File read error or file type not supported.
Press
SRC
to exit. Then press
SRC
to play disc again.
To Next Page
Loading...
