7
ENGLISH
Radio Mode
Selecting a Band
Press
BAND
once or more to select FM1 -
FM2 - FM3 - MW1 - MW2.
Display shows wave band, frequency, and pre-
set station number if already stored.
Selecting a Station
Press the or tuning button to tune to
another station.
Tuning
- AUTO SEEK
Press the
or buttons to seek the next/
previous station automatically.
- MANUAL SEEK
Press and hold the
or buttons to enter
manual tuning mode. Press the buttons again
to move the radio frequency number up or
down one step.
Note:
• During manual seeking, if the pause be-
tween two operating steps is longer than
5 seconds, when you continue to press the
or buttons, the unit will enter auto
seeking.
• During manual seeking, when you press and
hold the
or buttons, the unit will seek
continuously.
Preset Mode
Six numbered preset buttons store and recall
stations for each band. The stored stations
(1-6) for the current band can be viewed on the
screen.
Storing Stations
- Auto storing
1. Select a band (if needed).
2. Press
AMS
briefly to search all stations in
the band, the 6 strongest available station
will be automatically saved in the preset
button (numbers 1-6).
Note:
• After auto storing, the previous stored sta-
tions will be overwritten.
• The unit has 5 bands, such as FM1, FM2,
FM3, MW1, MW2, and each band can store
6 stations.
- Manual storing
1. Select a band (if needed), then select a sta-
tion.
2. Press and hold a preset button (numbers
1-6) on the front panel or remote control.
3. The preset number and station is displayed
and highlighted.
Recalling a Station
1. Select a band (if needed).
2. Press a front panel or remote control
preset button (numbers 1-6) to select the
corresponding stored station.
To Next Page
Loading...
