Need help?Do you have a question about the Blaupunkt THb 200A and is the answer not in the manual?
General| Power Output | 200W |
|---|---|
| Signal-to-Noise Ratio | >90dB |
| Impedance | 4 Ohm |
| Amplifier Class | AB |
| Bass Boost | 0dB - 12dB |
| Input Impedance | 10k Ohms |
Disconnect the negative pole of the battery before installation.
Ensure no vehicle components are damaged when drilling holes.
Extended positive and negative cables must have a cross-section of at least 2.5 mm².
The amplifier must be secured professionally in a dry location with air circulation.
The power cable must have a fuse within 30 cm of the battery.
The subwoofer box automatically switches on when a music signal is received.
The amplifier switches off automatically if no music signal is detected for over 60 seconds.
Connect to the positive pole of the battery and negative vehicle ground.
Connect via preamplifier outputs or loudspeaker outputs.
Use shielded sound cable for cinch (RCA) sockets.
Connect to closest loudspeaker cables, observing polarity.
Set sensitivity to minimum, phase to 0°, and crossover to approx. 80 Hz.
Adjust gain and crossover alternately for clear bass.
Set phase switch for optimal bass integration into the sound.
To Next Page