Operation
15
Solid State Digital Control with Humidaire
1
2
3
4
5
6
9
11
8
7
10
12
13
14
15
Figure 11
CONTROL DESCRIPTION
1. SELECTOR SWITCH - controls power to the
oven for high fan, low fan or cool down.
2. DISPLAY - displays time or temperature and
other information related to oven function.
3. HEAT LAMP - lights when heater is on.
4. PULSE LAMP - lights when Pulsed Fan Mode
is turned on.
5. HOLD LAMP - lights when Hold Mode is
turned on.
6. DIAL - used to enter set points in display
7. START/STOP KEY - starts or stops the timer.
8. TIME KEY - used to show time in the display.
9. TEMP KEY - used to show set temperature in
the display.
NOTE: Actual temperature is shown while the
TEMP key is held down.
10. HOLD KEY - turns Hold Mode on or off.
11. PULSE KEY - turns Pulse Mode on or off.
12. LIGHTS SWITCH - controls interior lights.
13. HUMIDAIRE START SWITCH - activates
moisture injection for a preset period of 30
seconds.
14. HUMIDAIRE LAMP - lights when water is beĆ
ing injected
15. CIRCUIT BREAKER SWITCH - controls powĆ
er to the oven.
To Next Page
Loading...
