Installation
9
Electrical Connection
Wiring diagrams are located in the control
compartment and on the back of the oven.
The electric motor, indicator lights and related
switches are connected to the oven as follows:
The service line will enter trough the rear of the
oven and connected to the terminal block (see diaĆ
gram).
1. Remove the bottom trim and control panel.
Removal of the body side is not necessary.
2. Remove knockĆout in the rear of the unit and
run the supply power line to terminal block
and connect the wires.
3. Reinstall the control panel and the bottom
trim.
NOTE: To prevent damage there is no power to
the heating elements when the blower is
not operating.
THE BLODGETT OVEN COMPANY CANNOT ASĆ
SUME RESPONSIBILITY FOR LOSS OR DAMAGE
SUFFERED AS A RESULT OF IMPROPER INSTALĆ
LATION.
Connect wires to
terminal block
Run supply line
through the knockĆout
Figure 8
To Next Page
Loading...
