Blue Clean AR142S - Garden Hose Adapter Setup

12
Garden Hose Adapter
• Install the garden hose adapter (GHA) and quick connect lter. It is made up of two separate
pieces. (1) A clear plastic adapter with a screen lter (about 3 inches long) (Fig. 13) and (2) a blue/
black collar attachment (Fig. 14).
• Attach the garden hose adapter to the end of the garden hose (Fig. 15).
• First, remove the plastic shipping cover on the water inlet on the front of the power washer on the
right side. Hand tight is ne. Slide the blue/black collar onto the clear adapter (Fig. 16), it will
“click” into place.
• The water is now connected to your power washer. Turn on water.
• To remove the water hose, simply pull back on the blue collar and it will slide off the clear adapter.
Note: this can be done at any time. Water will not come out of the garden hose as the blue/
black collar has a water stop check valve. Water will only ow from the garden hose when it is
connected to the clear adapter.
• You have now completed the assembly of your BLUE CLEAN POWER WASHER and are now
ready to begin using your electric power washer. Read and observe all safety instructions.
Fig. 16
QC - Clear
Adapter
Garden Hose
Adapter (GHA)
Fig. 15
(GHA)
Fig. 14Fig. 13