Slightly and gently pull on the four plastic tips of the probe. Be sure to remove the seal and
discard it. It could be stuck inside.
Scan the QR code of the new probe.
Remove the protective cap. Be careful not to drop the probe as it is a very fragile item. Place
the new seal supplied with the replacement on the new probe. Insert the probe and turn it
until it is placed correctly. Three beeps are emitted within 15 seconds.
Screw the nut firmly onto the device. Feel free to use adjustable pliers to tighten it properly.
Then, place the usage cap and place Blue Connect back in the water.
NB: The sensor may take a few hours to stabilise its parameters after its first immersion in the
swimming pool.
4.
5.
6.
7.
To Next Page
Loading...