bluelab Guardian Monitor Care And Use Guide

English
12
12.0 Set alarms (optional) cont.
Turn alarm ON/OFF
Press the alarm button to change between alarm ON and alarm OFF.
When the alarm is ON the alarm LED will glow.
NOTE: If you press and hold the alarm button you will enter the
alarm setting mode.
Alarm ‘detailed-set’
To set the detailed ‘alarm HIGH’ and ‘alarm
LOW’ values;
Press and hold the alarm button until ‘AL H’ is
displayed in all three windows.
Release the button and the current ‘alarm
HIGH’ values are displayed in each window.
To set conductivity alarm high value, press the
conductivity unit button then the up and down
buttons to change its value.
To set temperature alarm high value, press the
temperature unit button then the up and down
buttons to change its value.
To set pH alarm high value, press the pH
unit button then the up and down buttons to
change its value.
Press the alarm button to now select the low
alarm values.
Set the low alarm values the same way as you
did the high alarms.
Press the alarm button. SAVE is briey
displayed in the conductivity window and the
Guardian Monitor will return to its normal
monitoring mode.
NOTES:
To review current alarm settings without
changing the values, repeatedly press the alarm
button to step through the high and low alarms.
If you want to exit the alarm settings mode
without keeping any changes you have
made DO NOT press any keys. The Guardian
Monitor will ‘timeout’ and return to its normal
monitoring mode without saving any changes
after 1 minute.
The software will prevent you from setting low
alarm values higher than the high alarm values.
1
2
3
4
5
6
7
8

bluelab Guardian Monitor Specifications

General

Brand	bluelab
Model	Guardian Monitor
Category	Measuring Instruments
Language	English