9. Settings
The AC240 offers the convenience of adjusting its settings either via the LED screen or the
BLUETTI App. With the unit's LED screen, you have direct control over various settings
such as Power Lifting Mode, ECO Mode, output frequency, and charging modes.
Additionally, by using the BLUETTI App, you can access a user-friendly interface on your
phone to conveniently monitor and control the AC240.
9.1 Setting Mode
When the screen is on, press and hold the AC and DC Power Buttons for about 2 seconds
till the output frequency flashes to enter the Setting Mode.
9.2 ECO Mode
The AC240 has two ECO modes that help you save power and extend battery life:
• AC-ECO Mode
In this mode, if the AC power output falls below a certain level for a set period of time, the
AC power will automatically turn off.
Note: This mode is not available when the AC240 is charging from an AC source like a wall
outlet or generator.
• DC-ECO Mode
In this mode, if the DC power output falls below a certain level for a set period of time, the
DC power will automatically turn off.
Attention:
• The AC-ECO and DC-ECO modes are enabled by default to save energy, and it's
recommended to keep them enabled at all times.
• Use the BLUETTI App to enable or disable AC-ECO Mode and DC-ECO Mode separately.
If you use the LED screen, they'll be turned on or off at the same time.
• To avoid any interruption in charging, disable ECO Mode when charging a small device
that consumes less than 60W of power.
In the Setting Mode, press the DC Power Button to navigate through the setting items.
When the icon flashes on the screen, press the AC Power Button to enable or disable
the ECO Mode.
EN
JUST POWER ON
20
To Next Page
Loading...
