9.3 Frequency Switching
The current output frequency (50Hz / 60Hz) is displayed in the lower right corner of the
screen. In the Setting Mode, press the DC Power Button to navigate until the output
frequency appears on the screen. Then, press the AC Power Button to switch the frequency
options based on your requirements.
Note: Turn off AC Power Button before setting Frequency.
9.4 WiFi & Bluetooth Connection
To connect the AC240 to the BLUETTI App, turn on the WiFi or Bluetooth first. In the
Setting Mode, press the DC Power button to navigate through the setting items. When
the icon flashes on the screen, press the AC Power Button to turn Bluetooth on. Similarly,
when the icon flashes on the screen, press the AC Power Button to toggle WiFi on.
9.5 Power Lifting Mode
The Power Lifting Mode is specifically designed to handle resistive loads up to 3,600W,
including electric blankets, kettles, hairdryers, and other heating devices. To enable it,
access the Setting Mode, navigate with the DC Power Button until the appears, and
press the AC Power Button to enable the mode.
Note: The Power Lifting Mode is not enabled by default and is only suitable for resistive
loads with a power rating between 2,400W-3,600W.
Although the AC240 can handle higher power demands, its actual operating power
remains at 2,400W. Also, the mode is not available when the AC240 is working with
another AC240 unit in parallel.
9.6 AC Charging Mode
The AC240 supports 3 AC charging modes - Standard, Turbo, and Silent to fit your specific
needs. In the Setting Mode, use the DC power button to navigate until the or icon
starts flashing on the screen. Then, press the AC power button to choose the charging
modes. Please refer to the table below for useful instructions.
JUST POWER ON 21
EN
To Next Page
Loading...
