Bluetti D100P - Installation Requirements

1.2 Installation Requirements
• The installation and replacement should only be performed by qualified professionals.
• Before installing, disconnect the unit from the PV modules.
• Place the unit in a well-ventilated area and do not touch it, as the shell becomes hot and
can reach temperatures of up to 80°C (176°F) during operation.
• Ensure that the environment meets the requirements specified in the "Specifications"
section (protection class, temperature, altitude, etc.).
• In case of any damage to the power cable or the battery cable, contact professionals
immediately for a replacement.
• The transportation, wiring, and maintenance shall comply with all applicable laws,
regulations, and standards.
• User-provided materials and tools required shall meet the requirements specified in
applicable laws, regulations, and relevant standards.
• If the unit's shell is cracked during transportation or use, do not use it and contact
BLUETTI support or your local BLUETTI dealers.
• Use a dry powder extinguisher if the unit catches fire.
• In case of fire, EVACUATE the building or affected area immediately, activate the closest
FIRE ALARM system and call your LOCAL EMERGENCY NUMBER.
• Use genuine cables and accessories provided by BLUETTI.
• Keep the unit away from heat sources or high temperatures, and do not expose it to
direct sunlight.
• Do not store the unit with flammable liquids, gases, or explosive materials.
• Make sure the area where you are using the unit is well-ventilated and spacious.
• Contact BLUETTI support if this manual cannot adequately explain the malfunction to
you.
• Do not block or cover the unit's vents, as this may lead to a reduction in its power
generation capability.
Legal and Regulatory Requirements
Avoid working with live electrical components.
Danger
JUST POWER ON 07
EN