3.3 Space Requirements
• When setting up the D100P, it's important to avoid direct exposure to elements like
sunlight, rain, and snow.
• Leave at least 2 inches (5cm) of space around the D100P to allow for proper airflow and
heat dissipation.
3.4 Installation Procedures
3.4.1 Mount the D100P
The D100P provides a range of mounting options to suit different needs, including walls,
PV modules, module racks, and balcony railings. This manual presents an example of
mounting the D100P on the wall.
1.Use an impact drill with a 10mm bit to create appropriate holes in the wall. Make sure
the holes are at least 60mm deep.
2.Insert the M8*60 expansion bolts into the pre-drilled holes, then tap them in with a
hammer until the ends of the bolts are level with the wall surface.
3.Remove the nuts and washers from the expansion bolts. Thread the mounting slot of
the D100P through the bolts to temporarily secure it in place.
4.Use a tool like a socket wrench to firmly tighten the D100P in place using the nuts and
washers.
13
14
Vacuum Cleaner15
Mask
Safety-toe Shoes
No. Picture
Description
JUST POWER ON 13
EN
To Next Page
Loading...