1.2.1 Personnel Requirements
• The installation, electrical connection, commissioning, maintenance, troubleshooting,
and replacement of the unit should only be performed by trained professionals who
follow proper safety precautions and operating practices.
• To operate the BLUETTI unit, professionals must hold the appropriate qualifications and
certifications mandated by local regulatory authorities. These certifications cover tasks
such as high-voltage operations, working at heights, and specialized equipment
handling.
1.2.2 Drilling Requirements
When drilling holes in the wall or on the ground, the following safety measures should be
considered.
• Wear goggles and protective gloves at all times.
• Shield and protect the unit to prevent any debris from falling into it. After drilling, make
sure to remove all debris from the surrounding area.
• Avoid drilling holes directly on the unit, as this can damage its electromagnetic shield-
ing performance. Additionally, metal shavings from drilling can potentially cause short
circuits on the circuit board.
1.3 Radio Interference Statement
This PV Controller has been tested and complies with the limits set by CE RED, which
are designed to provide reasonable protection against harmful interference in residen-
tial installations. This PV Controller generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this PV Controller does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
1.4 Grounding Instructions
This product is classified as a Class I device and requires grounding. The device chassis is
equipped with a grounding screw mounting point. Please determine the grounding
method based on the actual installation scenario.
EN
JUST POWER ON
08
To Next Page
Loading...