Bluetti EP500Pro - Page 49

016
DC Input Voltage Low
Please contact the dealer if the symptom
persists after rebooting the unit.
017
DC Input Over Current
Please contact the dealer if the symptom
persists after rebooting the unit.
024
Phase Integration Error
Check the input wire and whether the“Master”
unit or “Slave”unit can work well.
025
AC Relay Short Circuit
Please contact the dealer if the symptom
persists after rebooting the unit.
026
AC Relay Open Circuit
Please contact the dealer if the symptom
persists after rebooting the unit.
027
Load Relay Short Circuit
Please contact the dealer if the symptom
persists after rebooting the unit.
028
Load Relay Open Circuit
Please contact the dealer if the symptom
persists after rebooting the unit.
029
INV Soft-Start Failure
Please contact the dealer if the symptom
persists after rebooting the unit.
018
Inverter Output Over Current
Please contact the dealer if the symptom
persists after rebooting the unit.
022
Inverter Output Short circuit
Disconnect and reconnect the load.
Clear the alarm history.
023
Inverter Over-load Protection
Disconnect the load. Please make sure your
loads meet the specifications of the unit.
Clear the alarm history.
019
Inverter Voltage High
Please check if the output of load meets the
specifications of the unit.
Turn on the AC after rebooting, and please
contact the dealer if the symptom persists after
rebooting the unit.
020
Inverter Voltage Low
Please check if the output of the load meets
the specifications of the unit.
Turn on the AC after rebooting, and please
contact the dealer if the symptom persists after
rebooting the unit.
021
Grid Input Over Current
Please check if the grid input current meets
the specifications of the unit.
Turn on the AC after rebooting, and please
contact the dealer if the symptom persists after
rebooting the unit.
49
JUST POWER ON