08
Owner’s manual
Intended use
Cleone is a water purifier for home use. Do not use it for any other purpose. Any use beside indoor
home environment and for purposes other than purifying water for household use is considered as
unintended use and will automatically void your Cleone warranty.
Water filtration system
Cleone cleans water in three steps: prefiltration, membrane filtration and postfiltration. Clean water
from Cleone is collected in the clean water tank. When the tank is full, Cleone is put in standby mode.
When the clean water tank level is low, Cleone opens the feed water supply and starts to clean water.
Water connections
There are four water connectors on the connection side of Cleone. The collet rings and tubing have a
color code.
Color Connection Description
ORANGE Feed water The feed water connection supplies feed water to Cleone.
RED Drain water Drain water from Cleone to the drain pipe contains flushed and
rejected contamination.
YELLOW Clean water tank Clean water is collected in the clean water tank before it is supplied
to the clean water faucet.
BLUE Clean water faucet Clean water from Cleone to the clean water faucet.
Intelligent membrane flush
The reverse osmosis filter is flushed with water during filtration and in standby mode. The membrane is
also flushed before the cleaning cycle starts. This makes sure that the cleaning process always starts
with fresh feed water.
Leak protection system
A sensor at the bottom of Cleone senses water leaks. If there is a leak, the feed water supply is
stopped. Cleone cannot be started again until the leak has been repaired.
Technical information
For more detailed technical information see www.bluewater.se
Parameter/Model Cleone Classic Cleone MIN Cleone UV Cleone MIN-UV
Size W×D×H [mm] 215×380×416 215×380×416 215×380×416 215×380×416
Weight [kg] 10.4 11 11.4 12
Power supply 95-240V 50-60Hz 95-240V 50-60Hz 95-240V 50-60Hz 95-240V 50-60Hz
Purified water flow rate
[l/day (GPD)]
160 (43) 160 (43) 160 (43) 160 (43)
UV lamp
Integrated mineral filter