What to do if filter I or filter II are blocked in my Bluewater Water Filtration System?
If filter I or filter II are blocked in your Bluewater water filtration system, make sure that nothing in the filter is obstructing the water flow. If necessary, replace filter I or filter II. No answer.
Why is the water flow low from my Bluewater Pro faucet?
Make sure that the clean water hose can move freely, because the clean water hose may be tensioned or jammed.
Why does my Bluewater Pro start and stop repeatedly?
Examine the connections. Ensure the ends of the water hose are circular and have no burrs. Also, make sure that the faucets and the valves are water tight when they are closed, because the water pressure between the water purifier and the faucet/valve/tank may be below the starting pressure level.
What to do if my Bluewater Pro Water Filtration Systems stopped because the tap was on too long?
Turn off the tap and wait at least 30 minutes. Alternatively, disconnect the water purifier from power and connect it again to start the automatic flush.
How to increase feed water pressure in Bluewater Water Filtration Systems?
Install a pump with increased pressure for the feed water. Also, do a check of the parts that have an effect on the feed water pressure (the water line, the coarse filter, the extra pre-filter).
What to do if Bluewater Pro Water Filtration Systems clean water quality is too low?
If it is a new water purifier calibrate it. If it is a used water purifier, disconnect it from power and connect it again to start the automatic flush. Repeat this 2 or 3 times.
How to reset emergency stop on Bluewater Water Filtration Systems Pro?
Disconnect the Bluewater Water Filtration Systems from power and reconnect it, or press the calibration button to reset the emergency stop.
What to do if Bluewater Pro Water Filtration Systems water quality meter is not working?
Disconnect the Bluewater Water Filtration Systems from power and connect it again to start the automatic flush. Do not use the water purifier for 2 hours.
What to do if filter I or filter II are blocked in Bluewater Pro Water Filtration Systems?
Make sure that nothing in the filter makes the water not flow. If necessary, replace filters.
What to do if there is water leakage or condensation on the base plate of my Bluewater Water Filtration System?
If you notice water leakage or condensation on the base plate of your Bluewater water filtration system, ensure all connections are watertight. Tilt the water purifier forward and dry the base plate with a cloth.
Detailed safety guidelines, warnings, and precautions for operating the water purifier.
Explanation of the leak sensor functionality and water supply interruption.
Details on the low pressure protection feature and manual restart procedure.
Guidelines for correctly positioning the water purifier in its installation location.
Step-by-step instructions for the installation of the clean water faucet.
Procedure for connecting the water purifier to the cold water supply.
Instructions for properly connecting the drain water tubing.
Final steps and connections required to set up the water purifier.
Procedure for flushing the water purifier after installation or maintenance.
Detailed steps for calibrating the water purifier to optimize performance.
Step-by-step guide for identifying and repairing leaks within the system.
Detailed instructions and precautions for performing the descaling process.
General| Brand | Bluewater |
|---|---|
| Model | Pro |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
