Bluewater Pro - After installation; Flush Pro; Do a check for leaks

15
© Bluewater Group 2016
After installation
When Pro is installed, and after each maintenance, the following procedures must
be perfomed before operation.
Flush Pro
Do not drink the water when the water purifier flushes. It is not safe to use.
The water purifier should always be flushed:
• when it is new and has not been used,
• when it is installed again after storage/freeze protection
• when it has been cleaned
• when the membrane has been replaced.
Figure 18.
3 2
1 2 3
30 s
10 min
4 5
Flush Pro
Do a check for leaks
The tubing connections must be tight!
Figure 19.
1
2 3
×6
Check for leaks