16
Complete User manual
Calibration
Do not drink the water that is produced when the water purifier is calibrated. It is
not safe to use.
If any of the purification level lights I-III does not go out, go through the checkpoints under
Flushing and restart the calibration.
If the purification level lights I-III do a wandering flashing light, restart the calibration.
Calibrate (reset) the water purifyer, to achieve a starting position for the degree of purification based specifically on your water.
Only calibrate the water purifyer if:
• it is new and has not been used before.
• the feed water quality changed (for example when the water purifyer has been moved).
• the membranes were replaced.
• the emergency stop must be reset.
21 43 5
max
10 s
10 min
6 7 8 9
Figure 20. Calibration
To Next Page
Loading...
