Bluewater Pro - Leak protection system; Low pressure protection

09
© Bluewater Group 2016
Leak protection system
A sensor at the bottom of the water purifier senses water leaks. If there is a leak, the feed water supply is stopped. The water
purifier cannot be started again until the leak has been repaired.
Low pressure protection
If Pro stops because of low pressure, the cause of the low pressure must be
removed. If not, the pump can be permanently damaged.
Low pressure restart function
Figure 7.
0.8-7 bar
(11-102 psi)
Manual restart after low pressure cause has been removed