Bluewheel HK400 User Manual

14
2. INSTALLATION INSTRUCTIONS
Remove the screws from the main
frame (# 6).
Remove the two M4 * 30 screws
above the spring on the steering tube
of the steering axle (# 4).
Attach the handlebar (# 3) with the
steering tube screws so it positions
away from the tread frame (# 5).
Connect the rear axle (# 2) and the
main frame (# 6) and tighten the
screws.
Insert the tread frame (# 5) over the
steering tube of the steering axle.
Remove the screws on the tread
frame (# 5). Connect the frame pis-
ton-rod (# 8) to the tread frame (# 5)
and tighten the two M8 * 75 screws.
Slide the frame piston-rod (# 8) into
the main frame (# 6) and secure both
together with the locking screw (# 11).
Place the washer back on the handle-
bar. Push the handlebar (# 3) with the
short side onto the steering tube.
Screw the seat (# 1) to the main frame
(# 6) with the four M5 * 16 bolts and
nuts.
1
2
3
4
5
6
7 8 9

Bluewheel HK400 Specifications

General

Brand	Bluewheel
Model	HK400
Category	Utility Vehicle
Language	English