Assembly
SERVO-DRIVE for
AVENTOS HK top
Installation of SERVO-DRIVE activation switch
NOTE: Use of boring template (M31.2000) recommended, see page 35
The activation switch should be installed by pressing into the
cabinet side with your hand. Do not use hammer to install.
11
12
30 min.
90 max.
Ø35
Installation of universal cable
Pull down orange universal cable
lock lever
Insert universal cable (either end of the
cable can be used)
Once cable is inserted, push up on
universal cable lock lever
1 2 3
Installation of Blum distance bumpers
NOTE: The distance bumper should not touch the SERVO-DRIVE switch
8*
Install into door front.
3
2
1
Dimensions in millimeters (inch equivalents as noted) © 2021 Blum, Inc.
25
To Next Page
Loading...
