SERVO-DRIVE for
AVENTOS HK top
E
Reset
Reset the drive unit to the factory setting.
Cover Cap Assembly, Switch Battery
Replacement, and Drive Unit Reset
Cover cap assembly
Replacing the SERVO-DRIVE switch battery
When the battery power begins to weaken, the battery display (LED) begins to flash red.
If the battery is inserted incorrectly, the SERVO-DRIVE switch battery display will flash red.
▀ Open the SERVO-DRIVE switch and
remove the battery
▀ Insert the new battery (type CR2032)
and close the SERVO-DRIVE switch
- note correct polarity +/-
Note: The SERVO-DRIVE switch battery must not be recharged or discarded into fire.
1
Press release button
on switch and remove
battery tray.
2
Remove old battery.
3
Replace with new
battery.
4
Insert battery tray
back into switch.
1
Press reset button.
2
Link button will flash continuously when reset complete.
Dimensions in millimeters (inch equivalents as noted) © 2021 Blum, Inc.
33
To Next Page
Loading...
