PLA88CS USER MANUAL
Contact: support@blustream.com.au | support@blustream-us.com | support@blustream.co.uk
13
Configuration Video Output Page
The Configuration Video Output Page allows the settings specific to the outputs of the Matrix to be changed as follows:
• The name of each output / zone
• Enable or disable CEC to the output
• Enable or disable HDMI Auto Downscale - this will enable/disable automatic conversion from 4K 60Hz 4:4:4 to 4K
60Hz 4:2:0 for displays that do not support 18Gbps HDMI signals, or down to 1080p. Downscaling will depend on
resolutions supported by the display device. Please note: Auto Downscale is only available on the HDBaseT™
output ports.
• Enable or disable PoC (Power over Cable) to power the connected HDBaseT™ Receiver. It is recommended to use
the Blustream RX150CS Receiver to support all features of this Matrix
• Enable or disable IR being transmitted out to a zone or from that zone output
• Set EDID Priority (output 1) to select whether the HDBaseT™ output or HDMI output should have priority for EDID
management.
Configuration Audio Naming Page
The Configuration Audio Naming page allows for audio inputs and outputs to be adjusted to human readable names,
such as the name of the source device, or the name of the zone output (eg: Kitchen, Bedroom, etc...)
To Next Page
Loading...
